landing gear

[chris]

Hello,

On the virtual panel the landing gear works correctly but on the FDS mip the gear is inoperative.

Although connected to a terminal block of an FDS SYS3 card in position 1 and 2 and detected by IITCreator at this location the lever does not act.

I think it is a configuration problem, so I would like to know what to put in IITCreator to make it work.

Thanks fot your answers.

Chris.

[chris]

So, no one to help me?

[jeehell]

You must not use the virtual panel at the same time as a hardware otherwise the virtual panel takes priority (it does not sync to the hardware).

[chris]

Hello,

Okay. Thanks for the reply, Does this mean that you absolutely must not load the gear, flaps, speed brake modules during installation, even if you don't use them?

but I still don't know what to put in IITCreator.

Should I assign switch up or toggle for switch 1, which is recognized as the gear up contactor, and switch 2, which is the gear down contactor, to switch dn or toggle ?

Regards.
Chris.

[jeehell]

Switch for GEAR UP position: on SW down action, select LDG GEAR UP in the list with push event.
Switch for GEAR DN position: on SW down action, select LDG GEAR DN in the list with push event.

[chris]

Hello Jean Luc,

Thank you very much, I configured it with your data and it works very well.

Regards.

Chris.