JeeHell FMGS forums

Hey guys did you have any tipps to Calibrate the spoilers ?

It a mess .....the rage between Off and Armed is too small to get it work.. i use an Original Lever connected to an Arduino Leonardo Interface

The Fluctuations are to high...

Hi, I have the same problem. I have limited it somewhat by limiting the upper limit. As a result, the value for the amred position is above the upper limit. Unfortunately this does not always work. Would be a good help if JeeHell could provide a range here that you could define for the amred position. By the way, I use a BU0836A interface board.

There will be a fix for splrs soon.

HI,
i have it like this and it works with version 61.9.0