Hey guys did you have any tipps to Calibrate the spoilers ?
It a mess .....the rage between Off and Armed is too small to get it work.. i use an Original Lever connected to an Arduino Leonardo Interface
The Fluctuations are to high...
Spoilers Calibration
Re: Spoilers Calibration
Hi, I have the same problem. I have limited it somewhat by limiting the upper limit. As a result, the value for the amred position is above the upper limit. Unfortunately this does not always work. Would be a good help if JeeHell could provide a range here that you could define for the amred position. By the way, I use a BU0836A interface board.
Regards
Stefan
I9-14900KF, RTX4090, P3Dv6, Immersive Display PRO, JH A320 FMGS on a dedicated Server
Stefan
I9-14900KF, RTX4090, P3Dv6, Immersive Display PRO, JH A320 FMGS on a dedicated Server
Re: Spoilers Calibration
HI,
i have it like this and it works with version 61.9.0
i have it like this and it works with version 61.9.0
regards from ETHL
Pete Fuss
P3D 5.4 ,Ryzen 7 5800X 3.80 GHz with 32 GB ,RTX3080 TI 12GB, MIxed Homecockpit + JH FMGS V B69.1.0, AS/ASCA, RdShade +Tex, CorteManager + ExtPWR from CaptPERO, a lot of add-on sceneries a round europe and the world
Pete Fuss
P3D 5.4 ,Ryzen 7 5800X 3.80 GHz with 32 GB ,RTX3080 TI 12GB, MIxed Homecockpit + JH FMGS V B69.1.0, AS/ASCA, RdShade +Tex, CorteManager + ExtPWR from CaptPERO, a lot of add-on sceneries a round europe and the world