IIT Creator B60

[Justin1974]

Hi,
I've just installed B60 and have been trying to co figure an old FDS Sys interface board. The board is recognised but I can only assign (and save) one switch before the application closes by itself.

Is this a known issue or am I doing something wrong?

Regards,
Justin Doxey

[jeehell]

Which version of FDS support did you install with my software?

[Justin1974]

Hi Jean Luc,
I think I ticked the legacy FDS?
Regards,
Justin

[Justin1974]

Hi Jean Luc,
I just tried it selecting new FDS module and that works...

Regards,
Justin