JeeHell FMGS forums

Hi,

Jeehell B58.0
When I set THR LVR1 and LVR2, the popup below is blank ("Choose LVR to setup"). I can no longer select a throttle.

I have done a complete reinstallation.

Have an nice day

best regards

Same Problem here with Skalarki TQ.
Temporary solution is to select the Lever 1 and 2 new.
After this you can select the levers in drop down box and set the values.

In the 57 the dropdown is selectable. Unfortunately not in 58.

you are right, but you can clear LVR1 and LVR2 and recognize both new.
Don't press the save button!
Next you can select LVR1 and LVR2 for the settings.
Hope this helps you, for the moment.

Unfortunately does not work.

I know WhatsApp you mean.
But dort do WhatsApp I say.
Clean the fields for l1 and L2 ther is a Button CLEAR!
Thema assign the axis New.

I just pushed a fix for that, please use the updater

Thanks for your answers. Unfortunately, the workaround did not work for me.

Now I have found another solution:

- Delete everything (THR) with CLR
- Select new
- Press Save
- Close Configure window
- Calibrate Throttle (in Windows-Controller-Settings [in my case an original Throttle Block runs over an Arduino Leonardo ETH])
- Start FMGS Server
- Close FMGS Server
- Open Configure again
- Now a selection is possible

Thanks for your inspiration

jeehell wrote: ↑Sun Apr 02, 2023 7:54 am I just pushed a fix for that, please use the updater

Thanks for the quick response!