JeeHell FMGS forums

Hello everyone
I still have this message F/CTL ALTN LAW (PROT LOST) MAX SPEED 320 KT
The plane no longer responds to manager and select orders. When I managed to make a flight at the time of the ILS approach when I disconnected the AP the plane started to pitch up on its own
I recalibrated the trottle, the rudders
I tried to restart ELAC 1 and 2, but nothing works, the problem persists
I'm using P3D v6.1
JEEHELL B 61.10
Cockpitsonic hardware except the CP FLIGHT CPU and the Skalarky timer
Which solution should I go for and how?
Many thanks for your help
Regards

Do you have anything on your SD status page?
Do you reposition the aircraft in the air at some point?

The flight plan is displayed well on the ND I have just done a test The plane takes off normally I do the usual manipulations, but the autopilot does not work and the speed caps at 140 kt Even in manual mode the trottle caps at 140kt
This is what I noticed
Greetings

I did not talk about ND but SD (lower ECAM), on STS page it can help.

Of course
After ignition of engines upper ecam message
F/CTL ALTN LAW PROT LOST
MAX SPEED 320 KT
FUEL CTR TK PUMP 2 LO PR
IF NO FUEL LEAK
FUEL
CTR TK PUMP 2 OFF
On lower Ecam
INOP SYS
F/CTL PROT
CTR KT PUMP 2
STATUS
MAX SPEED 320 KT
APPR PROC
FOR LDG USE FLAP3
GPWS LDG FLAP 3 ON
LDG DIST PROT LOST
IN GREEN ALTN LAW:PROT LOST
WHEN L/G DN: DIRECTLAW
In flight the throttle does not respect the speed levels The route is not followed despite the pilot activating it and if I adjust a direction by selecting the plane only tilts 5 or 6 degrees
Good reception
Regards