Page 1 of 1

RAT OUT

Posted: Mon Jul 08, 2024 4:08 pm
by gillesaqsim
Hello Jean-Luc,
release b61.4.2 (of course :) )
-since the recent wiring of my 21 VU (OVH) and registration in SIOC-creator, I've systematically with the RAT OUT message and naturaly at init power on FMGSA320 . Only an action in the P3d menu "STOW RAT" resolves the problem.
I can send you files for analysis.
no offset allows me to tinker with sioc or fsuipc.
Do you have any idea of ​​the origin of this little problem?

-also after read the logs files i 've always "D:\A320FMGS\Hardware Modules\borlndmm.dll not valid" in HClog.txt and 0 to 9.txt "is it serious doctor?" :)
best regard

gilles

Re: RAT OUT

Posted: Mon Jul 08, 2024 5:21 pm
by gillesaqsim
Image
my hardware is just a switch under a red hood and there is no light.
If empty , no PB?
regards

Re: RAT OUT

Posted: Mon Jul 08, 2024 5:48 pm
by jeehell
SIOC (or more correctly open cockpit boards) is known to sometimes badly initialize switch state, that could be your issue (particularly if nothing happens without the switch declared).

Re: RAT OUT

Posted: Sun Jul 14, 2024 9:55 am
by gillesaqsim
yes it's true JL ... i've suppress setting input button of MAN ON in sioc creator and now no RAT OUT message. i'll test with an other input already used and which don't generate problem.
If i don't resolve this, it would be nice to be able to have an fsuipc entry or STOW RAT assignment in fmgsconfig... you know that I don't like having to tinker in the p3d menu (not very aero and aesthetic)
also i post again the picture of my question about the curious OUTPUT for this puh button
Image
best regards and good holidays...
Gilles

Re: RAT OUT

Posted: Wed Jul 17, 2024 8:45 pm
by jeehell
that already exists, check 78ED value 35

Re: RAT OUT

Posted: Thu Jul 18, 2024 10:40 am
by gillesaqsim
reading diagonally doesn't do anything good!
thank's JL
Gilles