Problem sizing PFD/ND on 17” LCD and skalarki MIP panel

Ask questions regarding software support here
maddoc
Posts: 8
Joined: Wed Jun 17, 2020 7:11 am

Re: Problem sizing PFD/ND on 17” LCD and skalarki MIP panel

Post by maddoc »

bbruechmann wrote:
Tue Jul 28, 2020 2:01 pm
I have sized my screens with the priority to edge expansion at the top and at the bottom to fit into the cutout. This will end up that you have little space on left and right side, but thats like in the real ac. You can see on my pic that there are small additonal frames left and right of the screen, which come from the screen unit itself which can be pulled out of the mip for maintainance. You could add some thin plastic sheet stripes with a width arround 7mm to close the gap between the MIP cutout and the drawn screen graphic to have a similar look like in reallife airbus.
Thanks so much for advice 👍👍

Post Reply