Page 1 of 1
pitch/trim/mcdu/co disagree
Posted: Tue Apr 16, 2024 3:47 am
by turbovela
I’m having a pitch/trim/mcdu/co disagree warning. I use the CG on the MSFS weight and balance CG for now, also using 1/UP0 for note on the PERF page.
It started this new update. Anybody else having this issue?
Re: pitch/trim/mcdu/co disagree
Posted: Tue Apr 16, 2024 8:48 am
by gillesaqsim
Re: pitch/trim/mcdu/co disagree
Posted: Tue Apr 16, 2024 12:51 pm
by turbovela
I am inputing the values myself, I’m not using the uplink in the system and I’m still getting this error. With b60 if I put the values manually I had no issues, but not in b61.
Jose
Re: pitch/trim/mcdu/co disagree
Posted: Tue Apr 16, 2024 3:18 pm
by gillesaqsim
I have already reported this problem.... I don't want to "annoy" more.
also to avoid having an error with the TO CONFIG, I only enter the take-off flaps
Re: pitch/trim/mcdu/co disagree
Posted: Tue Apr 16, 2024 5:01 pm
by snooky_g
Jean Luc added two extra loading zones to the aircraft: ADJ FW and ADJ AFT and on the other hand he reduced the empty weight of the aircraft to roughly 32tons (empty weight of an A320: 43tons). You need to fill both of theese compartments with roughly an extra weight of 4tons, so the empty matches agan to 43tons. See the Fuel an Payload page within P3D. As of my understanding that was done, to adjust the moving CG during the flight. If you fill up both compartments, you T.O. calculation should be ok.