A320 FMGS B61

You can find here the latest versions, with changelogs, and documentation.
Locked
jeehell
Site Admin
Posts: 414
Joined: Thu Nov 03, 2022 10:14 am

A320 FMGS B61

Post by jeehell »

Hello,

here is the latest version:
https://www.jeehell.org/A320FMGS_B61.10.1.exe

The release log:
08/10/2024 B61.10.1
-Fixed SPLRs issues despite correct calibration


29/09/2024 B61.10.0
- Fixed pack not starting in case of XBLEED feeding with onside engine failed
- Fixed ECAM on single screen not cycling STS page properly
- Enhanced reverser behavior (acft won't move forward in idle REV)
- Fixed ALT CSTR not held on approach in some conditions
- Fixed VNAV profile when same ALT CSTR is on several points on the APPR route

25/08/2024 B61.9.0
-Fixed PFD/ND sometimes XFR'd on elec power up
-Work on probe heating computers (elec power and ecam display in case of faults)
-Fixed FDS USB MCDU issue (dataline not set, only on USB version)
-Fixed GPWS SYS button OFF inhibiting other FWC synthetic voice sounds (radio alts, etc)
-Fixed FCU/PFD selected speedifferent sometimes d
-Fixed PLAN mode not showing while ADIRS are aligning (initial ADIRS alignment is still needed ~30s)
-Fixed baro setting inhg/mb not correctly initializing with hardware
-Fixed pressurization LDG ELEV always reseting o 0ft in descent

21/05/2024 B61.4.2
-Fixed issues with ADIRS alignment,On BAT LED
-Fixed issues with FAC CG computation (FWC warnings should be more accurate)
-Fixed some SIOC Creator config issues with MCDUs
-Fixed StarterENGrun
-Fixed ADIRS LCD display in OVHD GUI
-Fixed V/S Indicator going out of scale at very high values
-Fixed some V/DEV scale logic issues with FLS/SLS/RNAV approaches
-Fixed LOC scale or VOR lateral deviation scale blinking continuously sometimes


04/04/2024 B61.3.9
-Fixed issues with steering

25/03/2024 B61.3.8
-Fixed issues with steering and A/BRK

20/03/2024 B61.3.7
-Reworked flight model
-Reworked FBW, mostly in roll and yaw channels
-Cosmetic changes on EIS (flags mostly)
-Fixed hold at PPOS changing when craeting a new TMPY FPLN
-Fixed some FLS/SLS/ILS/FINAL modes issues
-MCDU GUI: config now with a readable config file, may need to reconfigure it at first run. Fixed potential openGL issue with it.
Regards,
Jean Luc
Locked