JeeHell FMGS forums

Hello guys!
Who is using the vatsim vpilot.
I am using the acp and com panel on both side of my cockpit.

But only the com2 is possible to send and receive messages. The com1 is only possible to receive msg.

At the acp-cpt the com1 activated and at the companel is com1 (the first button) activatet (lighting).
At the acp-fo the com2 is activated and at the companel is com2 (the second button) activated (lighting).
I am using the intercomsoftware and using the virtuelle soundcards (installed with the cpt pero manual).

How has the same problem or how can help me to activate the com1 - that it can send and receive.

Best regards peter

Peter,

vPilot allow only 1 com TX at all time.

using the dot command to active which com to be Transmitt (TX)
https://vpilot.rosscarlson.dev/Document ... t-commands

You can map these command to you ACP buttons.
Or by using Event ID to assign

KEY_COM1_TRANSMIT_SELECT.......COM1_TRANSMIT_SELECT.........Selects COM 1 to transmit
KEY_COM2_TRANSMIT_SELECT.......COM2_TRANSMIT_SELECT.........Selects COM 2 to transmit
KEY_COM_RECEIVE_ALL_TOGGLE...COM_RECEIVE_ALL_TOGGLE...Toggles all COM radios to receive on