JeeHell FMGS forums

Hi Jean Luc,

we have updated to B60.0.2 but now the speed brake is not working anymore. We have a Poldragonet A320 Family Pedestal from symulatory.com. We can still arm spoilers. I performed the hardware configuration for the speed brake again but it still does not work. In the hardware config window I could see that the sensor values changed when the speed brake lever was used. So I think our hardware is ok.

Thank you.

Best regards,

Basti

I have updated to B60.0.5 but the speed brake still does not work. I also did the hardware configuratiin again. The value for SPD BRK retracted is 546 and for full extended is 866 in our case.

try with to replace the symulatory DLL this DLL :
https://www.jeehell.org/Symulatory.dll

Hi Jean Luc,

thank you for your reply.
I replaced the Symulatory.dll with the one you provided, but the speed brake still does not work.
I installed version B57.2.0 again and with this old version the speed brake works again. So I assume our speed brake lever is ok.

Best regards,

Basti

please try again , with the same link, I updated the file.

I tried again with the new version B60.0.6 and with the new Symulatory.dll file, but both did not work.