JeeHell FMGS forums

Hello Jean-Luc,
Sometimes the simpatcher modules does not start : I don't see it in the addons menu in P3D v5.
I added the lines in the dll.xml file as you recomanded on the installation guide.
Is there an explain ?
Is a way to lauch it manualy ?
Thanks in advance

the module starts after a couple minutes to avoid conflict with other addons which may interfere.
If it nevers starts, it could be that you need to increase the "sleep time" before it starts. Also, once started it takes some more time before it is fully operationnal (about a minute).

OK Thanks Jean-Luc

Hi Jean-Luc,

I tried sleepTime=180000 for FSX B60.0.2 but the Simpatcher Module never start (no Simpatcher and airfile in Modules Menu), I waited for 60 minutes. Simconnect.dll is version 10.0.61637 [FSX Acceleration]
Is there any other value that we can try for FSX ?
[config]
sleepTime=180000

Thanks

masterp wrote: ↑Fri Dec 08, 2023 3:03 am I tried sleepTime=180000 for FSX B60.0.2 but the Simpatcher Module never start (no Simpatcher and airfile in Modules Menu), I waited for 60 minutes. Simconnect.dll is version 10.0.61637 [FSX Acceleration]
Is there any other value that we can try for FSX ?
[config]
sleepTime=180000

Do you have any content in your simpatcher log?
I dont have that particular version of FSX. And I dont have FSX installed right now...

Hi Jean-Luc,

I attached the simpatch log file.
I tried changing value in simpatchConfig.ini to 120000 or 180000 but the module never start.

the new version was released let me know if it works for you.

Hi Jean Luc,

With fresh installation of B60.0.5, FSX is able to load the Simpatcher.DLL
However right after the message "Tables found" shown up in simulator, the aircraft started to rotating unstoppable.
Here is the Simpatcher.log
""
18:43:52 friction file:C:\A320FMGS\SimPatch\frictionPoints.ini
18:43:52 Friction Hack OK
18:43:52 sim1:10.0.61637.0
18:43:52 XwindOffset file exists:C:\A320FMGS\SimPatch\XwindOffset.ini
18:43:52 10.0.61472.0=$11110
18:43:52 2.5.12945.0=$111BA8
18:43:52 3.4.9.18400=$125778
18:43:52 4.5.11.29713=$1526A8
18:43:52 4.5.14.34698=$154AB8
18:43:52 5.1.8.26742=$1577E0
18:43:52 5.1.12.26829=$1577E0
18:43:52 5.2.18.27565=$157870
18:43:52 5.2.22.27615=$157880
18:43:52 5.3.12.28072=$157878
18:43:52 5.3.15.28131=$157878
18:43:52 5.3.17.28160=$157878
18:43:52 5.4.9.28482=$15B938
18:43:52 6.0.26.30799=$15CA40
18:43:52 6.0.27.30829=$15CA40
18:43:52 6.0.28.30845=$15CA40
18:43:52 6.0.30.30926=$15CA48
18:43:52 6.0.34.31011=$15CA48
18:43:52 6.0.35.31017=$15DA08
18:43:52 PreFoundXWINDoffset:0
18:43:52 XWIND Hack OK 1 times
18:43:52 XWIND Hack not preset for this version of P3D, not using the XWIND hack!
18:43:52 DllStart OK
18:44:12 SimConnect OK1
18:44:12 SIMCONNECT_RECV_ID_OPEN...
18:44:12 SIMCONNECT_RECV_ID_OPEN OK
18:44:13 loaded AIR File2:E:\Microsoft Flight Simulator X\SimObjects\Airplanes\A320\CLEAN.AIR
18:44:13 -restarthack...
18:44:13 found as_btstrp.dll
18:44:13 AS16_AmbientIcing @0x67365F88
18:44:13 AS16_AmbientTurbulence @0x67365EFC
18:44:13 AS16_ExportedPrecipType @0x67365EF4
18:44:13 AS16_ExportedPrecipRate @0x67365EF5
18:44:13 AS16_ExportedAmbientVisibility @0x673649E8
18:44:13 AS16_InCloud @0x67365F49
18:44:13 AS16_WshLat @0x67365FF0
18:44:13 AS16_WshLon @0x67366004
18:44:13 AS16_WshRange @0x67365F98
18:44:13 AS16_WshMinAlt @0x67365FAC
18:44:13 AS16_WshMaxAlt @0x67365FF4
18:44:13 SetRdrParams @0x6730B730
18:44:13 -restarthack ok waiting for tables scan
18:44:13 loaded AIR File2:E:\Microsoft Flight Simulator X\SimObjects\Airplanes\A320\CLEAN.AIR
18:44:13 -restarthack...
18:44:13 -restarthack ok waiting for tables scan
18:44:14 loaded AIR File2:E:\Microsoft Flight Simulator X\SimObjects\Airplanes\A320\CLEAN.AIR
18:44:14 -restarthack...
18:44:14 -restarthack ok waiting for tables scan
18:44:15 loaded AIR File2:E:\Microsoft Flight Simulator X\SimObjects\Airplanes\A320\CLEAN.AIR
18:44:15 -restarthack...
18:44:15 -restarthack ok waiting for tables scan
18:44:22 loaded AIR File2:E:\Microsoft Flight Simulator X\SimObjects\Airplanes\A320\CLEAN.AIR
18:44:22 -restarthack...
18:44:22 -restarthack ok waiting for tables scan
18:44:54 loaded AIR File2:E:\Microsoft Flight Simulator X\SimObjects\Airplanes\A320\CLEAN.AIR
18:44:54 -restarthack...
18:44:54 -restarthack ok waiting for tables scan
18:44:54 loaded AIR File2:E:\Microsoft Flight Simulator X\SimObjects\Airplanes\A320\CLEAN.AIR
18:44:54 -restarthack...
18:44:54 -restarthack ok waiting for tables scan
18:45:41 IsMultiAir
18:45:41 IsMultiAirNew
18:45:41 IsCmEffectNew
18:45:41 IsCDEffectNew
18:45:41 starting memory scan...
18:46:13 memory scan complete
18:46:13 found table 401 CL vs Mach 0D47FA5C
18:46:13 found table 404 CL vs AoA 0D480674
18:46:13 found CL linearized 0D480C5C
18:46:13 found Zero Lift Alpha 0D480C60
18:46:13 found rudder effectiveness 0B962B8C
18:46:13 found Stall Alpha 0D480C58
18:46:13 found Yaw Moment Cn_r 0D47F968
18:46:13 found SPLRS pitch Moment cm_ds 0D47F8F4
18:46:13 found SPLRS lift CL_ds 0D47F88C
18:46:13 found Pitch Moment Cm0 0D47F8CC
18:46:13 found Drag CD0 0D47F894
18:46:13 Tables found
18:46:13 Cm0 removed a changed entry
18:46:13 CD0 removed a changed entry
18:47:03 clds removed a changed entry
18:47:04 Cn_r removed a changed entry
18:47:04 cmds removed a changed entry””

Video of aircraft jumping.

ok that should be fixed with this simaptcher.dll to replace yours (only for FSX!)
https://www.jeehell.org/SimPatcher.dll

jeehell wrote: ↑Thu Dec 14, 2023 1:10 pm ok that should be fixed with this simaptcher.dll to replace yours (only for FSX!)
https://www.jeehell.org/SimPatcher.dll

Dear Jean Luc,
This Simpatcher.dll works really well on FSX.
Thank you very much for your continuous FSX support !!