JeeHell FMGS forums

After updating I cannot engage the autopilot. Ecan error warning. I also use updated Skarlaki and P3D 5.3

follow video of the problem

my settings p3d 5.3.17 and jeehell b59.1.2

Did you try update from yesterday?

I couldn't update because it failed

I tried the update several times but it failed and I couldn't find it and didn't understand why it failed.

You can get the full update https://www.jeehell.org/A320FMGS_B59.1.3.exe

When I get home from work I will update it via this link and get back to you

Good morning, with the link I was able to update and the autopilot problem was resolved, thank you.
I would like to take this opportunity to tell you about a problem that I have had for a long time, MCDU via remote doubles the function, I have tried all possible settings and it did not solve it, follow the link with video

How does the keyboard of your MCDU works? Looks a bit like it sends the characters "on press" and "on release" so in the end you have two.

the mcdu is connected to an mjoy electronic board and the configuration is done one by one within jeehell, remember that if I install it on the main computer and not via remote it works perfectly

Something in the remote option is duplicating the commands, I've already changed the mjoy board but the problem continues.

just to clarify the mjoy is a joystick board.