Offset 73AE always returns the value 0

[LH320]

I am using offset 73AE to control my motorized trim wheel. I have already posted that my SIOC code no longer works. According to the documentation the offset returns the value -9999 in manual mode and if not in manual mode it returns a value between -400 and +1350. For me the offset 73AE always returns the value 0. Has the offset been changed or is this a problem with P3dv6? Has anyone else observed this?

[jeehell]

I'll have a look. Not p3d V6 issue as far as I can tell.

[LH320]

I have found the cause. My mistake, I forgot to install FSUIPC Support . FSUIPC Support must always be installed on the PC running FMGS Server.
Problem solved.