JeeHell FMGS forums

Does anybody know how to adjust the sensitivity of rudder and brake pedals?

At the moment, I reach full rudder deflection after approx. 2 cm of movement and its quite hard to keep the AC in the middle of the runway. The brakes are also way too sharp.

Thanks in advance!

HI Alex, I too am interested in knowing the solution.
best regards,
Gilles

Really nobody?

Have you assigned the axes correctly in "Configure Controls" and calibrated them correctly via "Calibrate"?

See the "Installation Guide" PDF Chapter 4.2

balu69 wrote: ↑Mon Jun 26, 2023 7:41 pm Have you assigned the axes correctly in "Configure Controls" and calibrated them correctly via "Calibrate"?

See the "Installation Guide" PDF Chapter 4.2

Yes, I did. But unfortunately, there is no option to calibrate the sensitivity of the axes.

subsonic wrote: ↑Mon Jun 26, 2023 7:46 pm ...unfortunately, there is no option to calibrate the sensitivity of the axes.

that´s right! It isn´t. What you having in mind is a kind of response curve adjustment as some controllers provide within their driver software. As flight stick, for instance, i have a VIRPIL stick and have adjusted the response curve for it´s axes. That´s possible only because the VIRPIL driver software provide a very sophisticated axes adjustment.
Unfortunately the the controller setup of Jeehell doesn´t provide an adjustment of the response curve for a controller axis, yet. It would be a nice feature, especially for those who have standard controller boards like Leo Bodnar´s etc.

I´am not sure about, if it´s possible to use tools like Lorby´s Axis and Ohs for that part, together with Jeehell?!?