Error in SIOC Creator
Posted: Sun Jun 25, 2023 2:40 pm
When I make an assignment for the engine start panel (fire and fault) in SIOC Creator, new variables are created.
When compiling the Crator generates an error message.
I suspect that the variable name is too long. As far as I know, the max. length is 15 digits for variable-name in SIOC.
ENG1startFireuled has 17 digits.
In addition, one request. Master Warning and Master Caution has an upper and a lower LED. AUTOLAND as well.
In SIOC Creator I can assign only one LED under MISC. Would be nice if the second LED could also be assigned.
When compiling the Crator generates an error message.
I suspect that the variable name is too long. As far as I know, the max. length is 15 digits for variable-name in SIOC.
ENG1startFireuled has 17 digits.
Code: Select all
Config_SIOC ver 5.2 - By Manuel Velez - www.opencockpits.com
Open file "C:\A320FMGS\Hardware Modules\JeeHellWare.txt"
16:21:47
Phase 1
.OK.
Phase 2
ERROR! -
Line: 17 Var 7, name ENG1startFireuled, Link IOCARD_OUT, Device 1, Output 60
==> ENG1startFireuled
%FAILED%
In SIOC Creator I can assign only one LED under MISC. Would be nice if the second LED could also be assigned.