JeeHell FMGS forums

Hello,

since the update my Jeehell server is isolated.

No other PC, Cockpit Connect, etc. connects to the server.

I already reinstalled it and checked all settings.

Is there maybe a problem with the update?

Kind regards
Michael

Check antivirus and firewall are off.
Check the IP addresses as well.

No , here it's ok about B58. may be firewall (installation name different....) me I have a doubt, I delete all the firewall entries so that they are asked again when launching FMGS , an unhappy windows update. do you test to see each shared folders from each computeur.
may be you make the same error during install, this has happened to all of us.
good luck and thanks for telling us what was wrong!
Gilles

jeehell wrote: ↑Thu May 04, 2023 2:19 pm Check antivirus and firewall are off.
Check the IP addresses as well.

Firewall etc. was off. All IPs etc. correct.
After several reinstallations and reboots it finally works.
I don’t know what was wrong.

But I got another issue now.
The window for FDS Ethernet hardware is gone. I can’t setup the MCDUs.

When I go to the Modules folders the whole FDS module is missing, but was selected in the settings, it shows no filesize during installation.

FDS module with Ethernet option: you should now the normal FDS module (not the legacy not the MCDU).
Then run IIT creator, find your Ethernet MCDU in the list to the left, right click on it and assign it as MCDU (CPT or FO).

jeehell wrote: ↑Thu May 04, 2023 3:52 pm FDS module with Ethernet option: you should now the normal FDS module (not the legacy not the MCDU).
Then run IIT creator, find your Ethernet MCDU in the list to the left, right click on it and assign it as MCDU (CPT or FO).

Alright, I didn’t know that yet, seems like I still used the module from older versions.
Now it works, thank you.

But, I can’t setup the MCDU display on SIM-Display settings.
FO side works. But on CP side the lines don’t move when I press the keys.
All other MCDU functions work. Just not that setup.

Sorry to bother again.

I'll have look tonight hopefully. You are able to enter the display menu though?

jeehell wrote: ↑Thu May 04, 2023 5:49 pm I'll have look tonight hopefully. You are able to enter the display menu though?

That would be great.
The issue is on CP side only.
Yes it is possible to enter the Menu, just moving the lines is not possible.

I just copied the FO side settings file and renamed it as work around. Makes the lines better but not 100%.

Kind regards
Michael