JeeHell FMGS forums

Hello Jean Luc
I just installed the new P3D v6 with active sky updates for P3D v6
I installed your new b 59.1.2 and I noticed on the one hand dymamic light no longer works, that is to say that the lights of the plane are no longer reflected on the ground and the buildings And on the other hand when of the flight the autopilot disconnects all the time
Where can these problems come from?
Thank you for your work and your passion
Patrick

I too have had several auto-pilot disconnects with the new B59 version. They happened in various phases of the flight and there was no turbulence or bad weather. Really not sure what could be causing this.

Indeed, and I note among other things, that as soon as the plane changes trajectory following its flight plan, the disconnection occurs. However, the simmconnect is activated (file OK)
Patrick

In fmgs server options, go check the last option which is new, something like trim wheel feedback. Put it to no.
Make sure you have updated to the very latest auto update.

Thank you Jean Luc for your latest update The simulation works great now
I wanted to ask you for information on the taxi lights of the plane in previous versions when I turned on the lights, they illuminated the runway and the buildings but not anymore What should I do Thank you for your help
Sincerely
Patrick

I have done a short test flight with the latest update(and the new "trimwheel feedback" option set to 'no', which was the default) and haven't experienced the auto-pilot disconnect issue.
However one thing I noticed is that the trimwheel on my Skalarki hardware does not return to 0.0 anymore after landing.

My cockpitsonic trim does the same thing, just do a manual adjustment when taking off
I don't know if in reality the trim resets to zero automatically
Patrick

PATRICK-D wrote: ↑Thu Sep 28, 2023 6:19 pm My cockpitsonic trim does the same thing, just do a manual adjustment when taking off
I don't know if in reality the trim resets to zero automatically
Patrick

Hi Patrick,
in reality the Trim Wheel is set to Zero automatcly after Touchdown at landing. It should not turn to Zero at Takeoff. At Take-Off the Trim Wheels are controlled by Autotrimsystem and hold the trim value which was set in the Take-off-Performance Page of the MCDU while the Flightpase of Take-Off.

Thank you Bernd for these necessary details.
Sincerely
Patrick

However, I am trying to understand why before, when I activated the switches on my Overhead, I could see my taxi and Landing lights reflected on the runway and on the buildings, but not anymore.
Greetings
Patrick

Check this post:

viewtopic.php?t=182

Thank you so much