MCDU Display

[flambinet]

Bon jour Jean Luc,
since a few days, I have a problem with the CPT MCDU display.
I think it appeared after updating to B61.13.2
My system consists of 3 computers, one main running P3D and A320FMGS and 2 others
mainly for the screen displays. One of the two is used to display the Cpt MCDU.
The screen only shows 1 line, AIDS and another word on it on the left side and SIM on the right side

On the other two computers, I have loaded the CPT MCDU's for control, result normal display

I have then checked my hardware:
The MCDU screen has no problems, because it shows other documents.
I disconnected the screen from the computer, but the the MCDU did not show right on the
related computer screen. Same display as described above.
I went back to B61.13.1, including creting new .bin files, no change.

I am a bit lost, because I think I tried everything what I could think of.
Could it be that MCDU.exe on this particular computer is corrupted?
Thanks for your support.
Best Regards

[jeehell]

Try to delete cpt config file for the MCDU, and redo the configuration.

[flambinet]

Thanks Jean Luc for your quick reply.
Just to be sure. I delete (move the file to a different location) configMCDU.cfg
and restart A320FMGS with starter.exe. Right?
And configMCDU.cfg is building itself up during the start up process?

Thanks for a short confimation or correction.
Fritz

[flambinet]

Bon jour Jean Luc,
thanks again for your quick reply yesterday.
I did as per your advice, and deleted configMCDU.cfg in the folder MCDU.
But nothing happened after I started the program with starter.exe.
The same display as yesterday
Everything was done in administrator mode.
I am not sure what you mean with redo the configuration.
Could you please explain further.
Thanks, best regards
Fritz