ACP Status Offset

Ask here for software oriented support
Post Reply
dkreiskott
Posts: 211
Joined: Thu Dec 15, 2022 11:11 am
Location: Germany \ near EDDL
Contact:

ACP Status Offset

Post by dkreiskott »

Hi Jean Luc,

I'm looking for a way to read the status of the LED for the Mech Button on the ACP using an offset. I can't find anything in the documentation?
Regards
Dieter

A320 cockpit Prepar3d v5.4 with full voice control for ATC and ground crew
Developer of EWD Overlay and Home Cockpit Builder
jeehell
Site Admin
Posts: 413
Joined: Thu Nov 03, 2022 10:14 am

Re: ACP Status Offset

Post by jeehell »

There are too many LEDs for the ACPs to make them workable with FSUIPC.
Regards,
Jean Luc
gillesaqsim
Posts: 85
Joined: Fri Nov 04, 2022 5:36 pm

Re: ACP Status Offset

Post by gillesaqsim »

hello Dieter,
Do you use sioc creator?
if yes, it's possible to configure some set in ACP page of sioc creator, I don't know the operation of this indicator in the JEEHELL suite, nor even if it is capable of being requested knowing that this can only be done by an external action....
after set you retrieve the JEEHELL variable and you write: if var JL mech = 1 so offset (offset free) =1.....
do you know Sioc Languge?
best regards
dkreiskott
Posts: 211
Joined: Thu Dec 15, 2022 11:11 am
Location: Germany \ near EDDL
Contact:

Re: ACP Status Offset

Post by dkreiskott »

Hi Gilles,

no, I don't use sioc in my home cockpit.
Regards
Dieter

A320 cockpit Prepar3d v5.4 with full voice control for ATC and ground crew
Developer of EWD Overlay and Home Cockpit Builder
Post Reply