A320 FMGS B61
A320 FMGS B61
Hello,
here is the latest version:
https://www.jeehell.org/A320FMGS_B61.10.1.exe
Please also see this post about beta sound module:
https://jeehell.org/forum/viewtopic.php?t=233
It will become the new standard in a version or 2, so it's still open for suggestions etc...
The release log:
08/10/2024 B61.10.1
-Fixed SPLRs issues despite correct calibration
29/09/2024 B61.10.0
- Fixed pack not starting in case of XBLEED feeding with onside engine failed
- Fixed ECAM on single screen not cycling STS page properly
- Enhanced reverser behavior (acft won't move forward in idle REV)
- Fixed ALT CSTR not held on approach in some conditions
- Fixed VNAV profile when same ALT CSTR is on several points on the APPR route
25/08/2024 B61.9.0
-Fixed PFD/ND sometimes XFR'd on elec power up
-Work on probe heating computers (elec power and ecam display in case of faults)
-Fixed FDS USB MCDU issue (dataline not set, only on USB version)
-Fixed GPWS SYS button OFF inhibiting other FWC synthetic voice sounds (radio alts, etc)
-Fixed FCU/PFD selected speedifferent sometimes d
-Fixed PLAN mode not showing while ADIRS are aligning (initial ADIRS alignment is still needed ~30s)
-Fixed baro setting inhg/mb not correctly initializing with hardware
-Fixed pressurization LDG ELEV always reseting o 0ft in descent
21/05/2024 B61.4.2
-Fixed issues with ADIRS alignment,On BAT LED
-Fixed issues with FAC CG computation (FWC warnings should be more accurate)
-Fixed some SIOC Creator config issues with MCDUs
-Fixed StarterENGrun
-Fixed ADIRS LCD display in OVHD GUI
-Fixed V/S Indicator going out of scale at very high values
-Fixed some V/DEV scale logic issues with FLS/SLS/RNAV approaches
-Fixed LOC scale or VOR lateral deviation scale blinking continuously sometimes
04/04/2024 B61.3.9
-Fixed issues with steering
25/03/2024 B61.3.8
-Fixed issues with steering and A/BRK
20/03/2024 B61.3.7
-Reworked flight model
-Reworked FBW, mostly in roll and yaw channels
-Cosmetic changes on EIS (flags mostly)
-Fixed hold at PPOS changing when craeting a new TMPY FPLN
-Fixed some FLS/SLS/ILS/FINAL modes issues
-MCDU GUI: config now with a readable config file, may need to reconfigure it at first run. Fixed potential openGL issue with it.
here is the latest version:
https://www.jeehell.org/A320FMGS_B61.10.1.exe
Please also see this post about beta sound module:
https://jeehell.org/forum/viewtopic.php?t=233
It will become the new standard in a version or 2, so it's still open for suggestions etc...
The release log:
08/10/2024 B61.10.1
-Fixed SPLRs issues despite correct calibration
29/09/2024 B61.10.0
- Fixed pack not starting in case of XBLEED feeding with onside engine failed
- Fixed ECAM on single screen not cycling STS page properly
- Enhanced reverser behavior (acft won't move forward in idle REV)
- Fixed ALT CSTR not held on approach in some conditions
- Fixed VNAV profile when same ALT CSTR is on several points on the APPR route
25/08/2024 B61.9.0
-Fixed PFD/ND sometimes XFR'd on elec power up
-Work on probe heating computers (elec power and ecam display in case of faults)
-Fixed FDS USB MCDU issue (dataline not set, only on USB version)
-Fixed GPWS SYS button OFF inhibiting other FWC synthetic voice sounds (radio alts, etc)
-Fixed FCU/PFD selected speedifferent sometimes d
-Fixed PLAN mode not showing while ADIRS are aligning (initial ADIRS alignment is still needed ~30s)
-Fixed baro setting inhg/mb not correctly initializing with hardware
-Fixed pressurization LDG ELEV always reseting o 0ft in descent
21/05/2024 B61.4.2
-Fixed issues with ADIRS alignment,On BAT LED
-Fixed issues with FAC CG computation (FWC warnings should be more accurate)
-Fixed some SIOC Creator config issues with MCDUs
-Fixed StarterENGrun
-Fixed ADIRS LCD display in OVHD GUI
-Fixed V/S Indicator going out of scale at very high values
-Fixed some V/DEV scale logic issues with FLS/SLS/RNAV approaches
-Fixed LOC scale or VOR lateral deviation scale blinking continuously sometimes
04/04/2024 B61.3.9
-Fixed issues with steering
25/03/2024 B61.3.8
-Fixed issues with steering and A/BRK
20/03/2024 B61.3.7
-Reworked flight model
-Reworked FBW, mostly in roll and yaw channels
-Cosmetic changes on EIS (flags mostly)
-Fixed hold at PPOS changing when craeting a new TMPY FPLN
-Fixed some FLS/SLS/ILS/FINAL modes issues
-MCDU GUI: config now with a readable config file, may need to reconfigure it at first run. Fixed potential openGL issue with it.
Regards,
Jean Luc
Jean Luc
- Soarbywire
- Posts: 33
- Joined: Fri Nov 04, 2022 12:23 am
- Location: Sydney, Australia
- Contact:
Re: A320 FMGS B61
Thank you JL!
Re: A320 FMGS B61
Thank you very much for continuing to work on the P3D version!
Greetings
Stephan
P3D V5.4, Skalarki FCU, MCDU, RMP, ECAM, TCAS, own OVH-Panel and MIP with Leo Bodnar and Arduino, Thrustmaster TCA Captain Pack Airbus Edition, Thrustmaster TPR Pendular Rudder
P.S. translate by google
Stephan
P3D V5.4, Skalarki FCU, MCDU, RMP, ECAM, TCAS, own OVH-Panel and MIP with Leo Bodnar and Arduino, Thrustmaster TCA Captain Pack Airbus Edition, Thrustmaster TPR Pendular Rudder
P.S. translate by google
Re: A320 FMGS B61
Thank you very much for continuing support FSX.
I installed the latest 61.3.7, only issue so far is the tiller has no effect, nose wheel steering is not working… axis of Tiller in FMGS Config is normal.
I installed the latest 61.3.7, only issue so far is the tiller has no effect, nose wheel steering is not working… axis of Tiller in FMGS Config is normal.
Thanks,
Phuong Vu
Phuong Vu
Re: A320 FMGS B61
Try to put the files in the zip file below into your FMGS Server\PERF folder:
https://www.jeehell.org/PERF.zip
https://www.jeehell.org/PERF.zip
Regards,
Jean Luc
Jean Luc
Re: A320 FMGS B61
Hi JL,
with the version B61.3.8 the problems after landing always there, no chance to steer with the steering tiller or the rudder
regards
with the version B61.3.8 the problems after landing always there, no chance to steer with the steering tiller or the rudder
regards
regards from ETHL
Pete Fuss
P3D 5.4 ,Ryzen 7 5800X 3.80 GHz with 32 GB ,RTX3080 TI 12GB, MIxed Homecockpit + JH FMGS V B69.10.1, AS/ASCA, RdShade +Tex, CorteManager + ExtPWR from CaptPERO, a lot of add-on sceneries a round europe and the world
Pete Fuss
P3D 5.4 ,Ryzen 7 5800X 3.80 GHz with 32 GB ,RTX3080 TI 12GB, MIxed Homecockpit + JH FMGS V B69.10.1, AS/ASCA, RdShade +Tex, CorteManager + ExtPWR from CaptPERO, a lot of add-on sceneries a round europe and the world
-
- Posts: 179
- Joined: Fri Nov 04, 2022 4:07 pm
- Location: EDDL
Re: A320 FMGS B61
Hi Jean Luc,
What has changed from B61.3.9 to 61.4.2?
Thx,
Michael
What has changed from B61.3.9 to 61.4.2?
Thx,
Michael
Regards
Michael
P3D v5.4 | Skalarki | 3 projector 180° screen | i9-13900k | RTX 4080
Michael
P3D v5.4 | Skalarki | 3 projector 180° screen | i9-13900k | RTX 4080
Re: A320 FMGS B61
For me everything works, so I dont know. Could be old version of P3D/FSX which causes that.
Try to edit C:\A320FMGS\FMGS Server\PERF\CFM\aircraft.ini with following lines:
Try various settings here for these two lines (yes/no etc)
Try to edit C:\A320FMGS\FMGS Server\PERF\CFM\aircraft.ini with following lines:
Code: Select all
[AIRCRAFT]
useP3Dtiller=no
RudderToTillerPositionBinding=yes
Regards,
Jean Luc
Jean Luc
-
- Posts: 5
- Joined: Mon Apr 24, 2023 9:28 am
Re: A320 FMGS B61
Thank You is much for your hard work.
Just having a little issue, quick align of IRS not working. Kindly suggest a solution.
Just having a little issue, quick align of IRS not working. Kindly suggest a solution.
-
- Posts: 85
- Joined: Fri Nov 04, 2022 5:36 pm
Re: A320 FMGS B61
hi,
i use to the mech CALLS of 21VU (Ovh) which is not used in JL and I assigned it in fmgs-config (buttons) to ALIGN ADIRS at the end of the list, push event...
i use it when passengers are in a hurry!
i use to the mech CALLS of 21VU (Ovh) which is not used in JL and I assigned it in fmgs-config (buttons) to ALIGN ADIRS at the end of the list, push event...
i use it when passengers are in a hurry!
Re: A320 FMGS B61
Download of B61.9.0 via updater in my case failed on all PCs. Downladed .exe after "Failed Twice" has 0 KB. Download link here at the top works.
See you in the skies…
Re: A320 FMGS B61
Hi Jeehell
With the B61 I have a delay on the Flightcontrol on around 3 to 4s. On the B60 is all ok. Anyone the same problem?
With the B61 I have a delay on the Flightcontrol on around 3 to 4s. On the B60 is all ok. Anyone the same problem?
Re: A320 FMGS B61
There is no reason here, except if something is slowing down the software. Post your FMGS server logs at least.
Did you redo calibration and navdata?
Did you redo calibration and navdata?
Regards,
Jean Luc
Jean Luc
Re: A320 FMGS B61
I've found the error. Have forgot to run as admin. Now it looks good.