Abrupt nose down on selected ALT

Ask here for software oriented support
Post Reply
michael1508
Posts: 179
Joined: Fri Nov 04, 2022 4:07 pm
Location: EDDL

Abrupt nose down on selected ALT

Post by michael1508 »

Hi all,

since some months I am experiencing an abrupt nose down of the plane, when I pull the ALT knob for a selected lower ALT.
Before the movement was much softer.

This happens with different weights & balances. I can't say since when exactly. I just know, this wasn't the case before and I haven't made any changes to my flight model.

Decending in managed mode works fine.

Is this only me or do you experience similar?
Regards
Michael

P3D v5.4 | Skalarki | 3 projector 180° screen | i9-13900k | RTX 4080
masterp
Posts: 13
Joined: Fri Nov 04, 2022 4:20 am

Re: Abrupt nose down on selected ALT

Post by masterp »

I have the same issue, only when pulling the ALT Knob (OP DES)
Managed mode DES or V/S still smoothly pitch down.
Thanks,
Phuong Vu
Firefly77
Posts: 5
Joined: Sun Nov 13, 2022 6:28 pm

Re: Abrupt nose down on selected ALT

Post by Firefly77 »

Same here ! It started with B59…
Br Mic
My system:
i9-12900K @5.2GHz, RTX3090, Win10, P3D 5.3, 3x Optoma GT1070
Eintagsflieger
Posts: 2
Joined: Wed Mar 27, 2024 10:34 pm

Re: Abrupt nose down on selected ALT

Post by Eintagsflieger »

Same issue here, tested with B59.1 and B61 in Prepar3D V6.
Sometimes (not always) Open Descent is far too aggressive with 10° pitch down, sink rates of up to 8000 ft/min, and increasing speed.




My Workaround is to disconnect the Autopilot, pull ALT and wait for about 20 seconds until the FD normalises. Then engage the AP again.
Any ideas?
Last edited by Eintagsflieger on Mon Jun 24, 2024 7:09 am, edited 1 time in total.
masterp
Posts: 13
Joined: Fri Nov 04, 2022 4:20 am

Re: Abrupt nose down on selected ALT

Post by masterp »

I still had this issue with B61.4.2.
Autopilot Open Descent is too much aggressive pitch down, "Don't Sink" GPWS and speed increased close to Vmax red line.
Thanks,
Phuong Vu
User avatar
Capt. PERO
Posts: 102
Joined: Fri Nov 04, 2022 3:23 am
Location: Germany
Contact:

Re: Abrupt nose down on selected ALT

Post by Capt. PERO »

No issues with B61.4.2 and P3Dv5.3 so far. Just tested yesterday.
INIT A and INIT B pages in MCDU properly set?
Viele Grüße / with best regards,
Peter

: : : aviation.pero-online.de
Developer of SIMstarter NG P3D & Homecockpit Builder
Post Reply