wild trim on approach and HWConnect Accessviolation

[SimStar]

Hi, I´ve got two strange things on my last fights. Don´t know if this issues stick togehter or if the are indepenent each other.
I have installed latest B61.4.2 and using SKALARKI TQ 2014 Version.

On approach trim wheels become to move continuesly up and down. Trim values up to 10Up and more are reached. It seems that there will be stacked a huge amount of trim values, which has to be driven by TQ. At the same time, TQ doesnt reat in time on Levers, so speed could not be adjusted.
After touchdown Levers gonna work again in time.

Today at the same time wheels become to move, hardware connect throws an exception "access violation at address 5B55CD1F in module 'SIOCmodule.dll'. Read of address 06B63420."
So most of connected hardware got stuck and couldn´t be used anymore.

Any idea where the problem could be?

[SimStar]

No idea?

[jeehell]

yo ucan try to go in FMGS Server -> options and toggle "Pitch Trim Wheel Feedback"

[dkreiskott]

I'm on 61.4.2 too and have the same TQ 2014 from Skalarki. But I have no Problems with the TQ. Works as expcted.

[SimStar]

yo ucan try to go in FMGS Server -> options and toggle "Pitch Trim Wheel Feedback"

Hi JL, I did changed tis value to off and there was no improvement.
I am not able to fly without Autothrust. A soon as I discpnnect autothrust problems start to occur.
after touchdown, levers working in time again.
I try to make a video that shows problem.

@Dieter, which profiler version do you use? which settings did you apply to the TQ?

Regards Marco


Profiler Version on my system is 5.1.300.100

[SimStar]

Here is the video:

Until 3:30 all seems to works fine.
There after thrustlevers inputs doesnt match anymore and after landing, flaps up and speedbraks retract, all is working in time again.
So there must be something that occurs this behaviour.

[jeehell]

it seems hardware connects picks up delay.
Either the computer running it is too slow, or the networking has bandwidth issue.
Or another hardware module is clogging it up. You mentionned SIOCmodule, mayb can you try to isolate that module to another PC?

[SimStar]

Got it. Had to reset Skalarki settings for TQ axes. solved