Speed Brake not working

[basti]

Hi Jean Luc,

we have updated to B60.0.2 but now the speed brake is not working anymore. We have a Poldragonet A320 Family Pedestal from symulatory.com. We can still arm spoilers. I performed the hardware configuration for the speed brake again but it still does not work. In the hardware config window I could see that the sensor values changed when the speed brake lever was used. So I think our hardware is ok.

Thank you.

Best regards,

Basti

[basti]

I have updated to B60.0.5 but the speed brake still does not work. I also did the hardware configuratiin again. The value for SPD BRK retracted is 546 and for full extended is 866 in our case.

[jeehell]

try with to replace the symulatory DLL this DLL :
https://www.jeehell.org/Symulatory.dll

[basti]

Hi Jean Luc,

thank you for your reply.
I replaced the Symulatory.dll with the one you provided, but the speed brake still does not work.
I installed version B57.2.0 again and with this old version the speed brake works again. So I assume our speed brake lever is ok.

Best regards,

Basti

[jeehell]

please try again , with the same link, I updated the file.

[basti]

I tried again with the new version B60.0.6 and with the new Symulatory.dll file, but both did not work.