Autopilot Problem

[joao.fernandescmte]

After updating I cannot engage the autopilot. Ecan error warning. I also use updated Skarlaki and P3D 5.3

follow video of the problem

[joao.fernandescmte]

my settings p3d 5.3.17 and jeehell b59.1.2

[jeehell]

Did you try update from yesterday?

[joao.fernandescmte]

I couldn't update because it failed

[joao.fernandescmte]

I tried the update several times but it failed and I couldn't find it and didn't understand why it failed.

[jeehell]

You can get the full update https://www.jeehell.org/A320FMGS_B59.1.3.exe

[joao.fernandescmte]

When I get home from work I will update it via this link and get back to you

[joao.fernandescmte]

Good morning, with the link I was able to update and the autopilot problem was resolved, thank you.
I would like to take this opportunity to tell you about a problem that I have had for a long time, MCDU via remote doubles the function, I have tried all possible settings and it did not solve it, follow the link with video

[hamsterpilot]

How does the keyboard of your MCDU works? Looks a bit like it sends the characters "on press" and "on release" so in the end you have two.

[joao.fernandescmte]

the mcdu is connected to an mjoy electronic board and the configuration is done one by one within jeehell, remember that if I install it on the main computer and not via remote it works perfectly

[joao.fernandescmte]

Something in the remote option is duplicating the commands, I've already changed the mjoy board but the problem continues.

[joao.fernandescmte]

just to clarify the mjoy is a joystick board.