Sensitivity adjustment of rudder and brake pedals

[subsonic]

Does anybody know how to adjust the sensitivity of rudder and brake pedals?

At the moment, I reach full rudder deflection after approx. 2 cm of movement and its quite hard to keep the AC in the middle of the runway. The brakes are also way too sharp.

Thanks in advance!

[gillesaqsim]

HI Alex, I too am interested in knowing the solution.
best regards,
Gilles

[subsonic]

Really nobody?

[balu69]

Have you assigned the axes correctly in "Configure Controls" and calibrated them correctly via "Calibrate"?

See the "Installation Guide" PDF Chapter 4.2

[subsonic]

Have you assigned the axes correctly in "Configure Controls" and calibrated them correctly via "Calibrate"?

See the "Installation Guide" PDF Chapter 4.2

Yes, I did. But unfortunately, there is no option to calibrate the sensitivity of the axes.

[bbruechmann]

...unfortunately, there is no option to calibrate the sensitivity of the axes.

that´s right! It isn´t. What you having in mind is a kind of response curve adjustment as some controllers provide within their driver software. As flight stick, for instance, i have a VIRPIL stick and have adjusted the response curve for it´s axes. That´s possible only because the VIRPIL driver software provide a very sophisticated axes adjustment.
Unfortunately the the controller setup of Jeehell doesn´t provide an adjustment of the response curve for a controller axis, yet. It would be a nice feature, especially for those who have standard controller boards like Leo Bodnar´s etc.

I´am not sure about, if it´s possible to use tools like Lorby´s Axis and Ohs for that part, together with Jeehell?!?