Hi all,
I've a total strange issue with the Skalarki Throttle Lever. Everything is working quite well. Only the lever for ENG 2 can't be calibratet and has no fuction at all.
The whloe Skalarki Pedestal is connectet to a slave PC an the issue shouldn't be a fundamental configuration problem, cause lever for ENG 1 is working as expected and can be calibratet. Same for Spoilers and Flaps.
the only thing I can see is that both levers are recognized by the Skalarki I/O profiler on the slave PC.
The "Configure Controls" from JeeHell does just "see" the lever for ENG 1.
If anybody has some glue I would be really happy!
regards
Robert
Skalarki Throttle Lever for ENG 2
Re: Skalarki Throttle Lever for ENG 2 (resolved)
This has been resolved
Fun fact 1:
The Throttle Lever for ENG 2 was inside the Skalarki profiler configured as "Loudspeaker"
Don't ask me why, I've never been there...
Fun fact 2:
For the levers I would suggest to do a calibration inside the profiler and in the Jeehell axis configuration. Since I've done this yesterday, the detents are perfectly synchronized and even the REV settings are correct!
Fun fact 1:
The Throttle Lever for ENG 2 was inside the Skalarki profiler configured as "Loudspeaker"
Don't ask me why, I've never been there...
Fun fact 2:
For the levers I would suggest to do a calibration inside the profiler and in the Jeehell axis configuration. Since I've done this yesterday, the detents are perfectly synchronized and even the REV settings are correct!