B58 and TopCat

Ask here for software oriented support
Post Reply
dkreiskott
Posts: 177
Joined: Thu Dec 15, 2022 11:11 am
Location: Germany \ near EDDL
Contact:

B58 and TopCat

Post by dkreiskott »

Hi Jean Luc,

have you made any changes to the parameters of the aircaft?
I use TopCat and now the Airbus takes off even if I don't pull the stick.
Is it possible that the TopCat values are no longer correct?
Regards
Dieter

A320 cockpit Prepar3d v5.4 with full voice control for ATC and ground crew
Developer of EWD Overlay and Home Cockpit Builder
jeehell
Site Admin
Posts: 312
Joined: Thu Nov 03, 2022 10:14 am

Re: B58 and TopCat

Post by jeehell »

I havent changed the weight and balance stuff, nor the main aerodynamics features.
are you sure about your CG?
Regards,
Jean Luc
dkreiskott
Posts: 177
Joined: Thu Dec 15, 2022 11:11 am
Location: Germany \ near EDDL
Contact:

Re: B58 and TopCat

Post by dkreiskott »

At the moment I do some test with a short flight wit low fuel in eddl to find the problem with shaking.
That is not so real.
I will do a test, with a full FP and report back.
Thanks.
Regards
Dieter

A320 cockpit Prepar3d v5.4 with full voice control for ATC and ground crew
Developer of EWD Overlay and Home Cockpit Builder
dkreiskott
Posts: 177
Joined: Thu Dec 15, 2022 11:11 am
Location: Germany \ near EDDL
Contact:

Re: B58 and TopCat

Post by dkreiskott »

I have tested a short flight with correct params.
Take off was okay. I think, there is no Problem in a correct planned flight.
Regards
Dieter

A320 cockpit Prepar3d v5.4 with full voice control for ATC and ground crew
Developer of EWD Overlay and Home Cockpit Builder
Mato68
Posts: 63
Joined: Thu Nov 03, 2022 4:30 pm

Re: B58 and TopCat

Post by Mato68 »

Hi JL....many thanks for your update.....do I have to create a new plate for Topcat and EFB2 with your new update or can I use still the old one for data import?
Many thanks and kind wishes.....Mato
Mato68
Posts: 63
Joined: Thu Nov 03, 2022 4:30 pm

Re: B58 and TopCat

Post by Mato68 »

Ok....got it...Topcat is working and for EFB2 I created a new profile with correct Airfile Clean.
Greetings...Mato
Post Reply