Problems with the new update

[joao.fernandescmte]

Good night, after the update I can't change the squawk I've tried everything without success

[joao.fernandescmte]

the message below appears
SELECT DESIRED SYSTEM,
however, it only disappears when the FMGS is selected, not giving access to the Tcas page which, when selected, does not allow changing the transponder numbers

[joao.fernandescmte]

the lights were great, but whoever looks from the outside and in flight notices the navigation lights and strobe flashing disorderly, on the ground they are perfect

[jeehell]

I'll check the XPDr setting from MCDU MENU pages.
What do you mean with the lights?

[joao.fernandescmte]

The strobe and navigation lights flash erratically, out of rhythm and only when in flight. on the ground they blink normally

[Mackenroll]

I also have a problem with all the lights.
I use P3dv5 and the lights when the plane is stopped are normal, when the plane leaves the ground the lights go out of their positions. During the day the lights continue to glow brightly.

[joao.fernandescmte]

exactly, in flight the lights flash randomly and in other positions. I also use P3D V.5

[joao.fernandescmte]

I take the opportunity to ask about changing the XPDr numbers. after the flight plan is filled in, I can no longer change the numbers because the phrase SELECT DESIRED SYSTEM is left, below that does not go out. Jeehell stayed to take a look. Another thing that stopped working was the request in the FMGS of the metar

[jeehell]

Did you test the update I put a couple hours before your message?

[Mackenroll]

After the new update, the lights are working fine. I found out that the problem with the lights moving out of place is that they don't follow the wing bending.
otherwise everything is ok, thank you very much