ENG not working A320 / Thrust Lever

[jeehell]

there should not be any need for that, if you use the flight model which comes with the installer package...

[Mortime]

Sorry but i use the flight model which comes with the installer package. or must i import this model again in the P3D after update the SW ?

[Mortime]

Hello Jean luc,

is there already a solution for this ? Unfortunately I cannot do a SW update.

Best regards
Mortime

[jeehell]

Only solution is an update.

[Mortime]

Hello Jean Luc,

I am really sorry to say this, but I have a new problem now. I installed yesterday the latest version B58.
The problem with the thrust lever does not seem to occur anymore! Instead, a whole new set of problems that were not there before. The FCU does not work anymore. The speedbrakes and the flaps no longer work.
How did I proceed ? I renamed the folder of each computer => C:\A320FMGS and then ran the installation B58 again on each computer. In P3D I replaced the A320-214 Aircraft with A320 from the package. Most of it works. But the above things no longer. The speedbrake and flaps run via the said EHID driver. Unfortunately, this driver is very old and can no longer be updated.

I would be really grateful if you could support me. I can provide log data etc. I would like to try to isolate the problem with your help.
I say many thanks in advance.

Best Regards
Morti