ENG 1 Ignition fault - not starting

[digidax]

Description:
N2 spooling up normally by APU bleed, IGN A, 80 kg/h F.F, Bleed Air 34 PSI, Oil pressure 0 PSI

ECAM msg:
ENG 1 START FAULT
ENG 1 IGNITION FAULT
- NEW START IN PROGRESS

=> cranking, starting again with IGN B
-> fault again
=> cranking, starting again with IGN AB

Then ECAM msg: switch master ENG 1 off

Steps To Reproduce:
ENG selector => IGN, START
ENG 2 Master ON => ENG 2 starts, running
ENG 1 Master ON =>

Additional Information:
Jeehell v53.3.6
P3Dv5.1.12.26829
Skalarki P&P Hardware, no MAINT OVHD

Bug Tracker: https://www.christophpaulus.com/bugrepo ... hp?id=1649





In aircraft.ini is set: AUTOICE=no

Any Ideas?

[Lion65]

Hi, the only time I had a similar problem was when i had mistakenly selected the airbus with different engines, once I selected the CFM equipped Airbus it started normally.
Sorry if your problem is a different one.