JeeHell FMGS forums

Thanks for the follow-up, but flight controls check and work OK. During the TO phase, ailerons are flat.
in a couple of weeks, I will proceed with a complete re installation of P3D v6 and JH FMGS on the main and server computers.
I'll let you know how it turns out.

Rgds, Francis

First answer: No I nolonger have P3D v5 installed. Second answer: I did check fuel balance and weights and it is OK. Engines are running with the same power and I don't have the left wheel hanging out....The ruder actually autotrims but it is probably to compensate for the ailerons. When going to ma...

Thanks for the response... However, I doublechecked and all axis are disabled in P3D, I reconfirmed in the option page and ... no change :-( Viewing the aircraft from outside, you can see the ailerons moved on each wing as shown on the SD. Could the aircraft.cfg and/or the configAPFBW.cfg or else be...

Since I implemented p3d v6, I have had several problems which I can hardly resolve. The major one for the moment is that as soon as the plane gets airborn, before I turn on the AP, it turns to the left. Engaging the AP puts it almost back on track but the PFD shows the plane to the left of the fligh...

Hello, The skalarki module has not been updated by Marcin for P3D v6. So, when you start the module, it show that the simulator is not connected... However it is! if you just run your profile and operate your cockpit normally, it works perfectly well. At least it does that for me. Just ignore the re...

Hi!
Did you enable dynamic lights in P3D options and did you test it at night... It doesn't reflect on the tarmac with day light.

Rgds, Francis

Tested and it works well.
Thank's again.

Francis

Thank you Jean Luc, I will test this during the week end.

Rgds, Francis

Thank you Jean Luc!

Rgds, Francis

Hello, After updating the Jeehellware folder with the Navigraph manager, I duly compile the 12 bin files in the navdata folder and copy them to the ND's. So far so good. However, the navdata.dat files in the respective navdata1 and navdata2 folders do not get updated even after restart of the progra...

Hello, I'm at a loss... After moving from P3D v.5.4 and B58 to P3D v6 and B59 and updates, I cannot get the exterior lights to work anymore! I have checked all the paths referenced in the various addon files including the Jeehell addon.xml and made sure they point to the new V6 installation. I dont ...

Hello, I upgraded my F/O computer which was the only one Windows 7 and with the problem, to Windows 10 and changed the graphic card to an AMD GT 6800 series which is a rather old card with a driver (the latest one) that dates back to 2015. And it works! Obviously I can't tell if it is the graphic ca...

Hello Jean Luc,

I just tried B57.2 but I still have the same issue with my F/O PFD and ND computer. F/O MCDU runs fine.
Thanks a lot for the effort.

Francis

Thank-you Jean Luc,

It seems I will not have much choice but to update my computer... Give me a time frame (1,2 weeks maybe) for you to come up with another solution. More than that, I will spend the money and upgrade!

Regards, Francis

hello Jean Luc, I have the same problem. FO ND and PFD disconnect shortly after the server starts (I have a four computer system). The FO side runs on a window 7, 64 bits computer with an old GeForce GT730, while the rest runs fine and is on windows 10 with more recent GPU's. I tried to up date the ...

Hello!
Same problem for me... no contact with the front wheel.

Rgds, Francis

Great news! Look forward !

Thanks so much for the work.

Francis